vancouverasbestosremoval's blog

The procedure of bathroom asbestos removal may require class A or B licenses or none at all. The particular steps in a removal project depends on the licensing requirement. Here's an summary of the steps involved with a removal project that doesn't require licensing (based on guidelines given by Safe Work Australia):

Removal Process That Doesn't Require Licensing

The steps involved with this technique are quite easy, since the scope of this kind of project is small. In this situation, you're only coping with a small size bathroom with a maximum of 10 m2 of non-friable products (solid asbestos containing material). Take note that, around no license requirement exists for this type of work, all workers must certainly be properly trained on how to identify and safely handle asbestos.


Image result for vancouver asbestos removal


The process in such a project should include the following aspects (based on requirements by the Australian Work Health and Safety Regulations (WHS Regulations)):

(I) Unless the task is carried out at domestic premises, a copy of the workplace's asbestos register must certainly be obtained beforehand. Persons with managerial control of the workplace are required to supply this document.

(ii) Workers can then proceed to identify specific hazards within the workplace. This isn't just limited by the particular hazardous materials that must be removed. The removal team should also take into consideration various hazards that may arise as a result of removal process, as well as the surrounding environment.


Image result for vancouver asbestos removal


Several potential hazards include:

- Heat stress: working in confined spaces probably will cause heat-related hazards. That is especially so as a result of personal protective equipment (PPE) worn by workers. Therefore, proper assessment must certainly be made from the intensity of work, temperature, air movement, humidity, exposure to heat sources and physical areas of the workers. Moreover, the danger of heat stress could be alleviated through: job rotation, providing cool drinks, appropriately scheduled work-breaks, properly fitting PPE and demarcating shaded rest areas.

- Experience of airborne asbestos: Removal of friable products (asbestos containing material in form of dust) can disperse the harmful material in to the air. To control this risk, special enclosures can be utilized to curb airborne dust particles.

(iii) Once the precise workshop has been identified, signs and barricades should be erected around it. This will prevent intrusion by unqualified persons.

(iv) During the particular removal, it's strongly recommended that wet spray or saturation and water injection methods are utilized. These two methods are effective in suppressing asbestos fibers, unlike the dry method. However, the dry method works extremely well just in case the work area has live electrical conductors.

(v) Only the proper equipment, tools and PPE is employed during this process.

(vi) Decontamination facilities must certainly be readily available.

(vii) After removal, all asbestos waste must certainly be properly labeled and discarded, when possible.

(viii) Eventually, all PPE used during this method should also be discarded in an identical manner to the asbestos waste. Alternatively, it may be decontaminated, packed into sealed double bags and laundered in a facility that may launder asbestos-contaminated material.


Visit here: http://www.vancouverasbestosremoval.com

Share:

Archives